Items in Cart: 0
Total $0.00

Information

Home ~ Equipment ~ Instruments ~ Oscilloscopes ~ NanoVNA-F-V3.1 (NanoVNA)

Oscilloscopes

Product 3/5

larger image

NanoVNA-F-V3.1 (NanoVNA)

$252.00

10kHz~1500MHz (in 3 ranges) portable Vector Network analyser/analyzer with accessories and USB connection for charging and/or PC connection.

PROVISIONAL Specification:

Measurement Range: 10kHz -1.5GHz

RF Output: 9dbm (±2dbm)

Dynamic Range: 70dB (50kHz-300MHz), 60dB (300M-900MHz), 40dB(0.9G-1.5GHz)

Note - There may be errors caused by nonlinear transformation of fundamental wave when doing harmonic measurements.

SWR: <1.1

Display: 4.3 inch TFT (800 x 480 pixels)

USB Interface: USB type-C communication mode: CDC (serial)

Power: USB 5V 200mA, built-in 5000mAh battery, maximum charging current 2A

Scanning Points: 101 (fixed)

Display Tracking: 4, Marking: 4, Setting Save: 5

Scanning Time: about 1.9s/time (50kHz-1000MHz full frequency band)

Frequency Tolerance:<2.5ppm

Frequency Stability:<0.5ppm

Measurable "S" parameters, voltage standing wave ratio SWR, phase diagram, group delay, Smith circle diagram...

Battery: 19.0Wh (about 5000mAh after conversion) large capacity lithium battery

Shielding: metal shield for the RF front end, allowing the S2I to have a dynamic range better than 60dB over the full frequency range

Power bank function: 5V/1A

Display Support: Android-mobile and Apple Iphone

Open route length test (TDR): NanoVNA-F S11 parameter, SWR standing wave ratio test

UV9D antenna U-band standing wave ratio measurement, starting frequency: 300MHz, termination frequency: 600MHz, standing wave minimum frequency 441.000000MHz, SWR = 1.03.

S21 insertion loss measurement, low pass, high pass, band pass filter measurement.

Measuring 6.5M Ceramic Notch with NanoVNA-F

Measuring 10.7M ceramic filter using NanoVNA-F

A self-made low-pass filter was measured using the NanoVNA-F with a 3dB bandwidth of approximately 400MHz.

This item can use as a Power Bank, but it can work with Android Phone only!

Package List:

1 x NanoVNA-F-V2 meter

2 x 11SMA~11SMA RG316 cable 0.2m cable assemblies (NanoVNA-F is a standard SMA female connector, which is used to switch to M head and N head to better protect SMA female)

1 x set of calibration parts (50Ω standard load x 1, open circuit calibration piece x 1, short circuit calibration piece x 1. Using this included calibration set, the instrument can be calibrated to get good measurement results

1 x 31SMA double-socket adaptor

1 x 16SMA elbow male~female

1 x Type-C USB data cable

• Condition: New - fully tested and factory calibrated.

Other Details:

• Power: charge via USB supply and/or power-bank

• Serial No: TBA

• Height: 75 mm (3 in)

• Width: 140 mm (5.5 in)

• Depth: 20 mm (3/4 in)

• Weight: TBA grams